Non-Tariff Barriers

Non-Tariff Measure

NTM classification

B7: Product quality, safety or performance requirements 

Date when the measure came into force

01 June 2010 

Publication where the measure is specified

Government Gazette No. 33059, 1 April 2010 

Regulation where the measure is specified

Amendment To The Compulsory Specification For Motor Vehicles Of Category M2/3 

Country/Region applying the measure

South Africa 

The rationale of the measure

1.1 This specification covers the requirements for motor vehicle models of category M2 and M3, and minibuses, not previously registered or licensed in South Africa, designed or adapted for operation on a public road. NOTE Except where stated otherwise, a semi-trailer bus should comply with a/l the requirements of this specification, and. in addition, with any compulsory requirements for the category 0 or N portions of the combination
not covered by this specification.
1.2 The requirements of this specification shall, in so far as the parts already incorporated are concerned, apply in respect of an incomplete motor vehicle model supplied for further manufacture by one manufacturer to another, and the entire speCification shall apply to the vehicle after completion thereof by the last-mentioned manufacturer.
1.3 This specification does not apply to experimental or to prototype vehicles constructed or imported by the original manufacturers or importers for the purpose of testing, assessment or development.
1.4 The relevant requirements of this specification shall take effect on the dates as specified in schedule 1
1.5 Where a South African national standard, including an international standard or a UN ECE regulation adopted by South Africa as a national standard, is incorporated by reference into this specification, only the technical requirements/specification for the commodity and the tests to verify the compliance, apply 

Coded list of objectives

X: For purposes n.e.s. 

Description of the measure

3.6.1 Seats and seat anchorages
3.6.1.1 Excluding a minibus , a vehicle shall be fiited with seats and seat anchorages that comply with the relevant requirements given in SABS 1564: 1992, The strength (and their anchorages) of large passenger buses, as published by Government Notice No. 216 of 19 February 1993.
3.6.1.2 Excluding seating that is of the folding tip-up (jokey), rearward-facing or sideways -facing type, a minibus shall be fitted with seats and seat anchorages that comply with the relevant requirements given in SABS 1429:1987, Motor vehicle safety specification for strength of seats and their anchorages, as published by Government Notice No. 1878 of 4 September 1987. 

Reference of the measure

Regulation 3.6.1 

Measure also domestic

Yes 

Products affected by the measure.

Description

Seats and seat anchorages of motor vehicle of category M2/3
Category M2 motor vehicle, hereinafter referred to as a vehicle motor vehicle that is used for the carriage of passengers, that has at least four wheels, that has seating accommodation for more than eight passengers in addition to the driver of the vehicle, and Reproduced by Sabinet Online in terms of Government Printer’s Copyright Authority No. 10505 dated 02 February 1998 that has a maximum mass not exceeding 5 t
Category M3 motor vehicle, hereinafter referred to as a vehicle motor vehicle that is used for the carriage of passengers, that has at least four wheels, that has seating accommodation for more than eight passengers in addition to the driver of the vehicle, and that has a maximum mass exceeding 5 t 

Countries/Regions affected by the measure.

Description

All countries